Honda FF500 Manuel De L'utilisateur page 43

Clutch oil inspection
1. Stop the engine and set the tiller on a
firm level ground with the rear wheels
and tines.
2. Place a 60 mm (2.4 in) thick block under
the rear wheels as shown.
3. Remove the oil level check bolt, sealing
washer and check that the oil is level
with the lower edge of the oil level
check hole.
OIL LEVEL CHECK BOLT
4. Add the recommended oil if the level is low.
Oil capacity: 0.67 L (0.71 US qt, 0.59 Imp qt)
Recommended oil:
Use SAE 0W-20 Honda 4-stroke oil or SAE 0W-20 4-stroke motor oil that meets
the requirements for API service category SL or equivalent. Always check the
API service label on the oil container to be sure it includes the letters SL or
equivalent.
5. Reinstall the check bolt, a new sealing washer and tighten it securely.
• TORQUE: 54 N∙m (5.5 kgf∙m, 40 lbf∙ft)
40
60 mm (2.4 in)
BLOCK
OIL LEVEL CHECK BOLT
UPPER LIMIT
TINE
REAR WHEEL
SEALING WASHER
(Replace)