Honda FF500 Manuel De L'utilisateur page 55

Rotary installation:
1. Apply grease to the key and set it on the key groove on the rotary shaft.
2. Install the inner rotary by aligning the key groove of the inner rotary with the
key on the rotary shaft with ''R'' (right rotary) mark or ''L'' (left rotary) mark facing
outside as shown.
3. Install the spring washer and rotary setting bolt, and tighten the rotary setting
bolt securely.
Make sure that the rotary setting bolt is seated to the spring washer securely.
RIGHT INNER ROTARY
(Viewed from right side)
RIGHT INNER ROTARY
FRONT
52
''R'' MARK
KEY
LEFT INNER ROTARY
(Viewed from left side)
''L'' MARK
LEFT INNER ROTARY
ROTARY
SETTING
BOLT
ROTARY
SETTING
BOLT
SPRING
WASHER