Fine Tuning Of The Model Helicopter; Setting The Controller Component - E sky ECUREUIL XL Notice D'emploi

11. Fine Tuning of the Model Helicopter

a) Setting the Controller Component
In addition to the two electronic speed controllers for the electric driven motors, the controller component also has an
integrated Piezo gyroscope. This gyroscope system helps the tail of the helicopter to remain stable when hovering and
prevents it from swivelling to the side continuously due to air drafts or air turbulences.
The "GAIN" (1) control is used for adjusting the sensitivity of
the gyro. You can make these adjustments using a small
screwdriver.
The further you turn the adjuster to the right, the stronger
the corrections (speed differences of the two rotors) at an
uncontrolled turn of the helicopter.
If the adjuster is turned too far towards the right, the helicopter
will tend to show oscillating movements around the yaw axis
(rotor shaft). In this case, turn the adjuster a little bit towards
the left again to achieve the best reaction sensitivity
Use the "PROPORTIONAL" (2) control to affect the rotational
ratio of the two drive motors. You only need to change the
control if the adjustment range for the trim control is no longer
sufficient for the tail function.
Since both controls were already adjusted as best possible in the factory, you usually will not need to turn
the controls.
07/10
Figure 22
59