Rösle BBQ Station Videro Pure G2 Mode D'emploi page 71

If you follow these tips, your RÖSLE gas grill will give you many years of reliable service:
• Each time before using the gas grill, check the gas grill for any leaks using a soapy solution or leak
detector spray.
•
after barbecuing with marinades. They contain salt and attack the surface.
• You should rub a little oil into the surfaces of the grates after use.
• Do not leave your grill outside unprotected. After the grill has fully cooled down, you must protect it
against rain and snow with a suitable RÖSLE protective hood. Do not store the grill beside road salt.
• In order to prevent dampness, regularly remove the cover both in summer and winter so that the grill is
aired out and any accumulated moisture can be dispersed.
•
• Slight surface rusting can easily be removed with a cloth soaked in vinegar essence or with a
commercial rust remover. Observe the information of the cleaning agent manufacturer.
• Chipped enamel can be treated with touching-up paint to cover over the bare metal exposed and
therefore avoid rust.
•
Problem Solution
Appliance does not •
•
burner fault •
•
•
Grill does not STOP, turn off the gas cylinder and turn all valves to "•" OFF.
function properly DO NOT smoke.
•
•
•
•
any blockage from the hose. Turn off the gas cylinder again after a second and reconnect the
gas hose to the gas grill.
•
Remove the burners as described above. Check the gas valve outlets and use a thin metal
wire to remove any residues that might be causing a blockage. Place burner over the outlets
again and check whether the burner is now functioning properly.
•
No spark •
•
Uneven burner Have the burners been cleaned?
•
•
Food burns on the Your grill temperature is too low. Wait a few minutes before turning the food so it has time
grate to cook properly.
Check whether the shut-off valve of the gas cylinder is opened.
Make sure that there is enough gas in the cylinder.
Is there a kink in the gas hose? – Straighten out the hose.
Is it possible to light the burner with a long match? – Check the ignition system!
Check all gas connections.
Wait 3 minutes to allow the accumulated gas to disperse and then
procedure.
Fit burners exactly over the outlets.
Gas pipe is blocked:
Blocked outlets:
Check the burner regularly in order to ensure that it is free of insects and spiders which
burner are cleaned carefully so that there are no more obstacles. We recommend a tube
brush for cleaning the Venturi tubes.
The distance between the burner and the electrode should not be more than 5-8 mm.
minutes with all burners lit.
Clean the grill grates, fat catcher tray, etc., so that all fat deposits are removed.
– Clean the burners; remove all residues.
repeat the lighting