Rösle BBQ Station Videro Pure G2 Mode D'emploi page 57

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

6.
can light the burner.
It is possible to visually check the ignition system. Look at the Jet Flame ignition area at the side from a
8. If the burner does not light immediately, turn the control knob back to "•" OFF and wait 2 minutes to
allow the accumulated gas to disperse. Now you can repeat the ignition procedure.
9. When the main burner has been lit, repeat this process until all the burners are lit or until you have lit
all the burners you wish to use.
For the lowest setting, you turn the control knob anticlockwise to "MIN".
11. If you do not succeed in lighting the gas grill, refer to the section "Troubleshooting".
12.
position "•" OFF.
1. Before starting the lighting procedure, all control knobs must be set to the position "•" OFF.
2. Open the lid of the grill before you light the main burners.
3.
4. Check all gas connections for leaks. See section "Leak check"
5. Press the right-hand control knob inwards and slowly turn it anticlockwise to the position "MAX".
6. In exceptional cases, the grill can only be lit with a match.
burning match through the lighting hole on the right.
8. Once the right-hand burner has lit, the burner next to it can be
turned on and will then light automatically. Repeat the process
until all the burners are lit or until you have lit all the burners you
wish to use.
9.
particular requirements.
For the lowest setting, you turn the control knob anticlockwise to
"MIN".
If you do not succeed in lighting the gas grill, refer to the section "Troubleshooting".
11.
position "•" OFF.

Publicité

Table des Matières
loading

Table des Matières