Interior Cleaning And Sanitizing - Manitowoc SM Serie Manuel D'installation, D'utilisation Et D'entretien

Section 4

Interior Cleaning and Sanitizing

GENERAL
Perform an In Place Cleaning/Sanitizing procedure
monthly and a Cleaning/Sanitizing procedure every
12 months for efficient operation. If the ice machine
requires more frequent cleaning and sanitizing, consult a
qualified service company to test the water quality and
recommend appropriate water treatment. An extremely
dirty ice machine must be taken apart for cleaning and
sanitizing.
! Caution
Damage to the ice machine evaporator caused by
incorrect chemical usage is not covered by the
warranty. Use Manitowoc Ice Machine Cleaner (part
number 000000084) and Sanitizer (part number
94-0565-3) only.
IN PLACE CLEANING/SANITIZING PROCEDURE
This procedure allows monthly in place cleaning of all
surfaces that come in contact with the water system. The
ice machine requires disassembly and cleaning/
sanitizing a minimum of once every 12 months. The
quality of your potable water supply may require more
frequent cleaning intervals.
Use ice machine cleaner to remove lime scale or other
mineral deposits. Ice machine sanitizer disinfects and
removes algae and slime.
NOTE: All ice must be removed from the bin.
!
Follow all labels and warnings on cleaner and
sanitizer bottles.
Step 1 Prepare 4 oz (1/2 cup) of undiluted Manitowoc
Ice Machine Cleaner (part number 000000084 only) in a
container that will fit easily under the lifted water
shutters. Refer to page 18 to identify the water shutters.
Model
SM50
Step 2 Press the clean switch. The ice machine will
initiate a 2 minute harvest to remove any remaining ice
from the evaporator.
Step 3 Remove all ice from the bin.
Part Number 040001361 05/10
Warning
Amount of Cleaner
4 oz. (120 ml)
Step 4 Wait 3 minutes until the Clean light flashes, then
add the prepared Manitowoc Cleaner by lifting the water
shutters and pouring directly into the spray area.
Step 5 The ice machine will automatically time out a
ten minute cleaning cycle, followed by eight rinse cycles,
and stop. The Clean light will turn off to indicate the
clean cycle is complete. This entire cycle lasts
approximately 30 minutes.
Step 6 Prepare 1/2 oz (1 tablespoon) of undiluted
Manitowoc Ice Machine Sanitizer (part number 94-0565-3
only) in a container that will fit into the same area.
Model
SM50
Step 7 Press the Clean switch. Wait 3 minutes until the
Clean light flashes, then add the prepared Manitowoc
Sanitizer by lifting the water shutters and pouring directly
into the spray area. The ice machine will automatically
time out a ten minute sanitizing cycle, followed by eight
rinse cycles, and stop. The Clean light will turn off to
indicate the sanitizing cycle is complete. This entire
cycle lasts approximately 30 minutes.
NOTE: The ice machine will automatically continue from
the previous point before the clean cycle was initiated.
A. If the ice machine was in the ice making cycle,
the control board will start ice making again.
B. If the ice machine was in the off cycle, the
control board will turn off.
Step 8 Mix a solution of 1/4 oz. (7.4 ml) of sanitizer and
1/2 gallon (1.9 L) of water. Use a spray bottle, sponge or
cloth to sanitize the bin. Rinsing is not required.
Maintenance
Amount of Sanitizer
1/2 oz. (15 ml)
15