Emission Of Harmful Substances; End Of Cycle - Tecno-gaz EKSTRA PLUS PT002TTM Mode D'emploi

10
Toxic mists are produced by the liquids used to perform maintenance on the instruments. The door
seal is fundamental for safety in the working environment and hence, for the operator. Periodically
make sure that the door seal is perfectly efficient.
The liquids used, together with the relative mists, if any, are extracted through the chamber drain:
- at the end of the cycle
- if the cycle is interrupted (STOP button)
- if an error occurs that interrupts the cycle
TECNO-GAZ CANNOT BE HELD LIABLE FOR ANY DAMAGE DERIVING FROM IMPROPER
USE OF THE MACHINE.
11
The set end of cycle is indicated by a beep and FINISHED CYCLE appearing on the screen.
- Press OK to proceed according to the instructions on the screen
- Press the door to open it
Disconnect the instruments from the stations where maintenance has been performed

DRY THE INSTRUMENTS WITH A DRY CLOTH

DRY THE CHAMBER WITH A DRY CLOTH
The maintenance cycle is complete.

EMISSION OF HARMFUL SUBSTANCES

END OF CYCLE

ENGLISH
29