Tecno-gaz EKSTRA PLUS PT002TTM Mode D'emploi page 60

ENGLISH
FULL OIL TANK
FLASHES
SCREEN E104
SD NOT INSERTED
CYCLE NOT SAVED
SCREEN E105
DOOR OPEN
CYCLE NOT STARTED
SCREEN E106
CYCLE INTERRUPTED
SCREEN E107
26
OK
OK
OK
MICRO M2 NOT ACTIVE
OK
MICRO M2 NOT ACTIVE
CAUSES:
This is displayed when the level reaches the
maximum limit while
accompanied by a beep.
SOLUTIONS:
Suspend the filling operations and put the cap
on the filler inlet of the tank.
CAUSES:
Screen E105 appears if START is pressed and
no SD is inserted.
SOLUTIONS:
The cycle is launched and not saved if OK is
pressed to confirm. Insert the SD for the cycle
to be launched and saved.
CAUSES:
This is displayed when the cycle is launched
with the door open or when the closing device
does not work.
SOLUTIONS:
Press OK to confirm, close the door and restart
the cycle. If the screen with the door closed
means a faulty lock and require a technical
intervention.
CAUSES:
1) If STOP is pressed during operation, the
cycle is interrupted and screen E107
appears.
2) If a fault occurs in the lock during the
cycle, the cycle is interrupted.
SOLUTIONS:
1) Press OK and screen B appears.
2) Request technical support.
filling the tank,