Description Of The Software - Tecno-gaz EKSTRA PLUS PT002TTM Mode D'emploi

ENGLISH
7.3

Description of the software

Each area of the display shows figures and/or descriptions that represent the condition of the
machine during the process, or messages with which the user chooses or sets the various functions
available.
SCREEN A
DD-MM-AA hh-mm
TYPE OF CYCLE:
COMPLETE
SELECT STATIONS & CYCLE
AND PRESS START
SCREEN B = LAST CYCLE RUN
As described in Para. 7.4, area D is reserved for the description of the functions of the buttons below;
- On the left side, the DOWN ARROW moves the cursor down and the NEXT ARROW moves the
cursor to the right,
- At the centre, OK confirms the selection,
- On the right, EXIT returns to the main menu (screen B).
Only the MENU function is activated in screen B, with which the various options contained therein,
can be accessed.
Maintenance begins once the instructions in the previous paragraphs are carried out, the selection
described in area C is made and lastly START is pressed.
16
Operate the main switch at the back of the machine
(Fig. 15) for it to be powered and "Screen A", which
displays the manufacturer logo and the version of the
software, appears for a few seconds on the display.
The main screen (Screen B) that appears immediately
after the manufacturer logo is divided into four areas:
A, B, C and D.
A
- The date and time appear at the top, in area A.
B
To the right and left of the date and time, the symbols
of the tanks that contain oil and detergent indicate the
relative status (full, empty or intermediate).
C
The last cycle performed appears in area B. The
MENU
D
alternatives cycle is retrieved by pressing the SELECT
button (LUBRICATION and EKSTRA).
The instructions to set the maintenance are displayed
in area C.