Installation - CombiSteel 7489 Serie Mode D'emploi

For an optimum functioning of the unit it is advisable to place the refrigerator in a zone with a good
!
exchange of air and far away from any sources of heat.
6.1 SETUP
Figure 1

Carefully remove the packaging from the refrigerator;

Remove the white PVC protection film from the stainless steel and all the protection used by the
company to reduce the risk of damage during transport;

Place the refrigerator on a flat level surface (use the adjustable feet)(Fig. 1)
Before use, clean the refrigerator with a clean, soft cloth or using a spray product. It is best use little water as it
contains minerals which leave traces which are difficult to remove quickly;

Wash the tray and all the internal parts using anti-bacterial detergents to be found commercially;

Remove the detergent with a soft sponge soaked in water and dry with a clean soft cloth;
Do not use abrasive detergents or powders which could make the finish opaque. During these phases do not, as
already stated, use great quantities of water which could damage electric parts;
a damp sponge is sufficient.

Place the self-support inside the refrigerator, in the most suitable position for use, inserting each
support in to the holes on the base of the refrigerator and inserting the side tab in the appropriate
place on the sides or on the table supports. (Fig. 2)

Slide the shelf into the supports as shown in. (Fig. 2)

Slide into the appropriate runners, on the lower part of the refrigerator, the condensation waste tray
and for appliances which have automatic trays, connect the connector. (Fig. 3)
6.2 PREARRANGEMENTS

Check that the cables and the sockets are suitable for the power absorbed by the equipment.
THE USE OF ADAPTORS, MULTIPLE SOCKETS AND/OR EXTENSION LEADS IS FORBIDDEN.

Ensure that the upright and/or table refrigerator is not installed near to sources of heat like: ovens,
radiators, direct sunlight etc.

Leave a space of at least 75 mm (3 inches) between the back of the upright and/or table refrigerator
and any wall, to avoid the formation of condensation.

The motor must be free of any obstacle which could hinder or limit the circulation trough the
condensing unit situated on the top side part of the refrigerator.

The distance between the refrigerator and the ceiling must be less 50 cm. (19 ¾ inches).

Check that the environment has a sufficient change of air, in order to guarantee the cooling of the
condenser and the compressor unit.

6 INSTALLATION

Figure 2 Figure 3
15