Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. INSTALLATION AND OPERATION
5.1 Safety instructions
WARNING! Electrical hazard!
The device must only be connected to a properly installed single socket with protective contact.
Never yank cord to disconnect from outlet. Cable must not touch any hot parts.
• See that the cable does not touch any heat sources or sharp edges. Do not let the cable dangle
over the counter edge.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation! Before installation the local power
grid specification should be compared with that of the device (see type label). Connect the
device only in case of compliance! Take note of the security advice!
5.2 Installation and connection
CAUTION!
Installation and maintenance of the device may be carried out only by qualified personnel.
ASSEMBLY OF SLIDING TRAY SHELF (fig.3)
•
For mounting the brackets (3) of the sliding tray shelf, use holes "A" and "B" (the upper openings of the
wooden panel). First, remove the plugs from the openings.
•
Mount the bracket (3) on the wooden panel, by screwing bolt "1" in opening "A" and bolt "2" in opening
"B".
•
Mount the sliding tray shelf (1) on the brackets and adjust its position using the attached spacer bolts
(2).
If necessary, the sliding tray shelf can be folded (fig.4)
www.combisteel.com
8
Publicité
Table des Matières
