Getting Started - ESAB KHM 525 PS Emploi Et Entretien

GETTING STARTED

fter having prepared the machine charged the
1)
battery, put in oil and fuel the machine is ready
for operation.
efore starting the engine please note the following
he welder should only be operated by qualified
personnel with experience in working with engine
driven welders.
heck the oil level daily. uel should be put in
before starting the engine.
efore using the welder or the auxiliary power let
the engine warm up and before stopping the engine
let it run without load to cool down.
Refer to the following instructions regarding the
function of the various controls on the front panel.
OFF
ON
START
Start the engine of the welder
2)
urn the welding current voltage
3)
adjusting knob to the minimum
setting.
USE WELDING DIGITAL CONTROL
SETTING THE WELDING PROCESS
here is a manual switch for selecting the various
welding processes on the welding control panel.
here are processes to choose from
for I welding
for S I welding electrode
for I welding continuous wire .
he switch can also be set to stand by
position . In this position there is no current at the
welding connections led
he process can be selected either before or after
starting the motor powered welder.
fter selecting the mode, the
the wirefeeder connector is connected on remote
control connector the
button torch is pressed.
M
33.
1
first
off.
ED lights up. If
ED light only when the