ESAB KHM 525 PS Emploi Et Entretien page 35

INSTALLATION AND ADVICE BEFORE USE
IMPORTANT
☞
Read and understand these instructions.
☞
Before installing, operating or servicing this
equipment, read the operating manuals of the welder
and of the engine.
☞
Not observing the information in the manuals can
result in personal injury and/or damage to the
equipment and other property.
☞
Respect all safety regulations and laws when operting
this equipment.
WARNING
Do not remove or disable protective devices
Removing or disabling protective devices on the machine is
prohibited.
Do not use the machine if it is not in good technical
condition
The machine must be in good working order before being
used. Defects, especially those which. regard the safety of
the machine, must be repaired before using the machine.
☞
FIRST AID. In case the operator shold be sprayed by accident, from corrosive liquids a/o hot toxic gas
or whatever event which may cause serious injuries or death, predispose the first aid in accordance with the
ruling labour accident standards or of local instructions.
Skin contact
Eyes contact
Ingestion
Suction of liquids from
lungs
Inhalation
☞
FIRE PREVENTION. In case the working zone,for whatsoever cause goes on fire with flames liable to
cause severe wounds or death, follow the first aid as described by the ruling norms or local ones.
Appropriated
Not to be used
Other indications
Particular protection
Useful warnings
WARNING
Wash with water and soap
Irrigate with plenty of water, if the irritation persists contact a specialist
Do not induce vomit as to avoid the intake of vomit into the lungs, send for a doctor
If you suppose that vomit has entered the lungs (as in case of spontaneous vomit) take the
subject to the hospital with the utmost urgency
In case of exposure to high concentration of vapours take immediately to a non polluted zone
the person involved
EXTINCTION MEANS
Carbonate anhydride (or carbon dioxyde) powder, foam, nebulized water
Avoid the use of water jets
Cover eventual shedding not on fire with foam or sand, use water jets to cool off the
surfaces close to the fire
Wear an autorespiratory mask when heavy smoke is present
Avoid, by appropriate means to have oil sprays over metallic hot surfaces or over electric
contacts (switches,plugs,etc.). In case of oil sprinkling from pressure circuits, keep in
mind that the inflamability point is very low.
WARNING
THE MACHINE MUST NOT BE USED IN AREAS WITH
EXPLOSIVE ATMOSPHERE
KHM
ENGINE FUELLING
⇒ Stop engine when fuelling.
⇒ Do not smoke, avoid open flames and sparks, and do not
use electric tools when fueling.
⇒ Unscrew the fuel cap slowly to let out the fuel vapours.
⇒ Do not over-fill the tank.
⇒ Avoid spilling fuel on hot engine.
⇒ Wipe up spilled fuel before starting engine.
⇒ Shut off fuel cock, if present, or remove fuel from tank
before moving machine
FOR BATTERY EQUIPPED UNITS ONLY
⇒ Sparks may cause the explosion of battery vapours
WATER COOLED ENGINES ONLY
⇒ Slowly unscrew the cooling liquid cap of a hot engine to
allow vapours to escape.
⇒ Hot vapor and heated cooling liquid under pressure can
burn face, eyes, skin.
CAUTION
M
2.5