Getting Started - ESAB KHM 405 YS Manuel D'instructions

GETTING STARTED

1) After having prepared the machine (charged the
battery, put in oil and fuel) the machine is ready
for operation.
Before starting the engine please note the following:
- The welder should only be operated by qualified
personnel with experience in working with engine
driven welders.
- Check the oil level daily. Fuel should be put in
before starting the engine.
- Before using the welder or the auxiliary power let
the engine warm up and before stopping the engine
let it run without load to cool down.
Refer to the following instructions regarding the
function of the various controls on the front panel.
OFF
ON
START
2) Start the engine of the welder
3) Turn the welding current/voltage
adjusting knob to the minimum
setting.
USE WELDING DIGITAL CONTROL
SETTING THE WELDING PROCESS
There is a manual switch for selecting the various
welding processes on the welding control panel.
There are 5 processes to choose from:
1 for TIG welding
3 for STICK welding (electrode)
1 for MIG/MAG welding (continuous wire).
The switch can also be set to "stand-by" (first
position). In this position there is no current at the
welding connections; led "ON" off.
The process can be selected either before or after
starting the motor powered welder.
After selecting the mode, the "ON" LED lights up. If
the wirefeeder connector is connected on remote
control connector the "ON" LED light only when the
button torch is pressed.
M
33.
1