Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TIG MODE
ontact starting I
his position is specifically for I welding. o cre
ate the arc simply place the tip of the I electrode
on the piece that requires welding then gently move
the tip away. he arc starts automatically and at the
same time the welding current rises to the preset
value, first using the welding current adjustment
knob which is on the lower part of the control panel.
he welding current can be adjusted continuously
from a minimum of
depends on the power of the machine
.
WARNING
or E
version it is compulsory to accelerate
the engine manually.
STICK MODE (Electrode)
eatures . .
onstant urrent
here are three stick modes which feature
increasing arc forces so that the arc has different
levels of penetration according to the electrode
and or welding position.
MIG/MAG MODE (continuous wire)
eatures . .
onstant oltage
ll wire type welding processes can be carried out,
naked or coated.
he voltage can be adjusted using the same knob
which adjusts the current in S I
djustment is continuous and goes from a minimum
of
to a maximum of
Optional remote control
he welding current can also be set from a distance
using the optional remote control. nce the remote
control is connected to the connector
current is controlled by the remote control. o return
to front panel control remove the connector.
Optional VRD program
RD
hen you choose the program stick or stick arc
force the
pen
ircuit
light switch
and green light switch
only for about
, than the
light switch on and red light switch
and stop there, until the welder start welding.
hen you make a short circuit with the stick the
immediately go up, so you can start to welding.
RD don t work with the program
USE
to a maximum which
,
.
oltage Reduction Device
oltage
go up, red
go down, green
, about
I
Inversion of polarity (Optional, available on
request)
In order to invert polarity, press the switch on the
remote control unit.
y selecting inversion the
and the voltage at the welding socket becomes
ero.
he power contactor is witched inside the
electrical box and the voltage reappears at the
welding sockets. he
at the same time.
he Invert polarity
,
,
welding current adjuster switches on .
ou cannot invert polarity in "MIG/MAG" mode.
PROTECTIONS
he
elding Digital ontrol features
for the control and chopper.
1) "ON" LED blinking
goes to the stand by mode for few istants stand by
ED on and performs a self diagnosis of the current
sensor connector and power source voltage
than the last process is loaded on led turned
In case of malfunction the "ON" LED blinks.
2) Red LED blinking
temperature exceeds
mode.
If the protection intervenes, the red ED begins to
flash and the welding current voltage goes to ero.
In this case do not switch off the welder, since the
alternator fan will help cool down the chopper more
quickly.
fter a few minutes, the
switch itself off and the welding voltage current will
once again be available at the plugs.
, the
3) Red LED continuously lit
welding current voltage goes to ero and the red
ED lights up. o reset everything, it is necessary
to switch off the machine.
, bat
If the protections
best to immediately contact the nearest authorised
Service
DIGITAL INSTRUMENTS
.
ptional, available on request
wo digital instruments showed the operating value
of welding current and welding voltage.
WELDING DIGITAL CONTROL
ED switches back on
ED on the front panel near the
hen the engine of the welder is
started the control unit automatically
he chopper has a thermal protection,
which intervenes in case the operating
.
ED will automatically
If an anomalous current is detected in
the chopper, the control blocks the
conversion immediately, the output
and
should intervene, it is
entre.
M
33.
2
ED switches off
protections
.
Publicité
Table des Matières
