ESAB KHM 525 PS Emploi Et Entretien page 39

DIESEL ENGINES
· Use in open space with fresh air flow or vent exhaust
gases far from the work area.
POSITIONING T E MAC INE
Place the machine on a level surface at a distance of at least
1,5 m from buildings or other structures.
If the surface is not level be sure that the angle of the machine
does not exceed the values shown in the drawings below.
PRECAUTION (ENGINE DRIVEN WELDER) KHM
☞
Assure that the hot air and/or exhaust gas from the
machine are vented and are not recirculated in the machine.
Hot air and/or exhaust gas which is recirculated wll cause
overheating of the machine and poor combustion in the engine
☞
Make sure that the machine does not move during
operation.
MOVES OF T E MAC INE
☞
At any move check that the engine is off, that there
are no connections with cables which impede the
moves.
PLACE OF T E MAC INE
ATTENTION
For a safer use from the operator DO NOT
fit the machine in locations with high risk of
flood.
Please do not use the machine in weather
conditions which are beyond IP protection
shown both in the data plate and on page
named "technical data" in this same manual.
M
2.6