Information On Assembly - Sportplus SP-MR-030-R-iE Mode D'emploi

CAUTION –RISK OF INJURY
• Do not use the product if it is damaged or defective. In this case, contact a
professional workshop or our service center.
• Always verify that the product is in impeccable condition before use. Defective
components must be replaced immediately as failure to do so may impair the
functioning and safety of the product.
• Make sure that no more than one person uses the product at a time.
• Always use the product on a horizontal, level, nonslip and solid surface. Never
use the product near water and make sure there is a safety clearance of at least 1
meter on all sides of the product.
• Prevent your arms and legs from coming near the product's moving components.
Do not put any objects into any openings on the product.
CAUTION – PRODUCT DAMAGE
• Do not alter the product in any way and use only original replacement parts. Have
all repairs carried out in a professional workshop or from similarly qualified persons
- improper repairs can lead to serious risks for the user. Use the product for the
intended purposes as described in the operating instructions only.
• Shield the product from spraying water, moisture, high temperatures and direct
sunlight.

INFORMATION ON ASSEMBLY

• The product should be carefully assembled by a responsible adult. Ask for the
assistance of another, technically-skilled person in case of doubt.
• Before beginning assembly of the product, read all assembly steps carefully and
review the diagram.
• Remove all packaging materials and lay out all the parts. This will give you a
good overview and simplify assembly. Shield the assembly surface from filth and
scratching by laying down suitable padding.
• Check the components against the components list to make sure all are present.
Do not dispose of all packaging materials until assembly is completed.
• Please note that there is always a risk of injury when using tools to carry out
manual tasks. Therefore, please exercise caution when assembling this product.
• Make sure your work environment is hazard-free. For example, do not leave any
tools lying around.
• After assembling the product according to the instructions, make sure that all
screws, bolts and nuts are installed correctly and tightened.
• If necessary, lay out protective padding (not included) beneath the product to
protect your floor as there is no guarantee that, for instance, the rubber feet will not
leave marks behind.
SP-MR-030-R-iE-IM-INT-V01.indb 36 SP-MR-030-R-iE-IM-INT-V01.indb 36
36
20 Aug 2021 7:55:45 am 20 Aug 2021 7:55:45 am