Bartscher E 5230 Manuel D'instructions D'origine page 82

Cleaning glass door
B
CAUTION!
When refitting the inner glass make sure that the drain edge (B) is directed
towards the cooking compartment, otherwise the door will not close tight.
Maintenance provided by the service technician
o Request regularly (at least once a year) the device maintenance performed by a
qualified expert service technician. Contact the service office to do so.
o Before any maintenance work, disconnect the device from the power supply and
close the water supply. Wait to let the device cool down.
o Before moving the device to another place make sure that the power supply and water
supply are correctly disconnected.
o If the device is placed on a wheeled base, make sure that the electric wires, pipes or
other elements are not damaged.
o After the operation has been performed and the device placed on a new place, make
sure the electric and water supplies are connected in accordance with the legal
requirments.
- 78 -
o The double glazing makes the device door
cleaning easier. You can half-open the inner
glass or remove it if necessary.
o To do so, loosen the upper and lower locks that
block the inner glass. Turn the locks clockwise
❶
(fig. ).
❶
o Open the inner glass (fig.
o Clean both sides of the inner glass and the door
of the device using relevant cleaning agents.
o Do not use aggresive or abbrasive cleaning
agents.
o Clean and dry the draining edge (A) that drains
away the water condensing between the inner
and outer glass.
o After cleaning, close or refit (if removed) the inner
glass and block the locks turning them anti-
A
clockwise to reach their initial position.
❷
❷
).