Bartscher E 5230 Manuel D'instructions D'origine page 75

Preheating
T 2
D 4
T 11
To turn the device on, press the button
The function buttons
the device is ready to accept function settings.
The LED display
T 1
To select the desired cooking/baking mode
press the corresponding button:
T 3
T 4
and set the desired parameters.
Pre-heating is turned off in basic settings.
T 4
To activate pre-heating, press button
turn dial M to the left. The LED display D 4 will
read "PRE? N" (N – no).
M
Turn dial
reads "PRE? Y" (Y – yes).
To confirm, press dial
in order to return to programming the recipe.
If we activate the cooking programme by
pressing button
D 4
and will read "PRE" and "HEAT".
After pressing
tically begin preheating at a temperature 20%
higher than the set for the first phase of cooking.
Once the pre-heating process is complete, an
acoustic signal sounds. Now the food may be
placed in the oven for cooking.
T 16
Note:
For best results, the food should always be
placed in the oven compartment the when
preheating is completed.
In addition, the pre-heating can always be
M
used when the power of the oven is to be
increased (with some specific exceptions where
the cooking needs to be started at "cold").
T 2 – T 3 - T 4
D 4
will read "MANUAL".
to the right, until the LED display
M
. Turn dial
T 16,
the LED displays
T 16
button the oven will automa-
T1
.
will flash, and
T 2 T 3
or or
T 11,
and
D 4
M
to the right
D 3
- 71 -