Installation Planning; Location And Clearances; Outside Combustion Air - Napoleon HYBRID 150 Mode D'emploi

8

3.0 INSTALLATION PLANNING

KEEP HAND TOOLS IN GOOD CONDITION, SHARPEN CUTTING EDGES AND MAKE SURE TOOL HANDLES ARE
DO NOT USE MAKESHIFT COMPROMISES DURING INSTALLATION. DO NOT BLOCK OR RESTRICT AIR. DO NOT
3.1

LOCATION ANd CLEArANCES

DO NOT INSTALL INTO ANY AREA HAvINg A HEIgHT LESS THAN 6 FEET 3 INCHES (1.9 M) (CAN BE
REDUCED TO 6 FEET (1.8 M) WHEN SHIELDINg SpECIFICATIONS ARE MET).
THIS AppLIANCE, CONFIgURED WITH ALL MODULES, WEIgHS: HMF150 - 700 LBS (318 kg), HMF200 -
830 LBS (375 kg). ENSURE THERE IS ADEqUATE FLOOR SUppORT FOR THE AppLIANCE.
THE vERTICAL HEIgHT OF THE AIR INTAkE LINER MUST NOT BE gREATER THAN ⅔ THE HEIgHT OF
for detailed clearance to combustibles, see Section 6.0 for plenum and consideration of venting location.
3.2

OuTSIdE COmBuSTION AIr

DO NOT DRAW OUTSIDE AIR FROM gARAgE SpACES. ExHAUST pRODUCTS OF gASOLINE
DO NOT DRAW OUTSIDE AIR FROM ATTIC SpACES, BASEMENTS OR ABOvE THE ROOFINg
WHERE OTHER HEATINg AppLIANCES OR FANS AND CHIMNEYS ExHAUST OR UTILIzE AIR.
THESE pRECAUTIONS WILL REDUCE THE pOSSIBILITY OF AppLIANCE SMOkINg OR AIR FLOW
THE OUTSIDE AIR INLET MUST REMAIN CLEAR OF LEAvES, DEBRIS ICE AND/OR SNOW. IT MUST
BE UNRESTRICTED WHILE AppLIANCE IS IN USE TO pREvENT COMBUSTION AIR STARvATION
WHICH CAN CAUSE SMOkE SpILLAgE AND AN INABILITY TO MAINTAIN A FIRE. SMOkE SpILLAgE
NEgATIvE pRESSURE WITHIN YOUR HOME MAY INADvERTENTLY AFFECT YOUR AppLIANCE.
ExHAUST FANS SUCH AS BATHROOM FANS, RANgE HOODS AND CLOTHES DRYERS CAN
AIR INLET TERMINALS MUST BE INSTALLED WITH ADEqUATE gROUND CLEARANCE AND BE
SUFFICIENTLY SHIELDED FROM pREvAILINg WINDS TO pREvENT FROM REvERSINg IN THE vENT
The napoleon Hmf150/200 may take outside combustion air directly into the appliance through a 4" (102 mm)
inlet collar at the back of the unit. This inlet is to supply combustion air for the Hmf150/200 Wood furnace
only.
Secure and seal the intake liners to the collars using 3 sheet metal screws, and high temperature sealant.
insulating the intake liners is recommended in colder climates to prevent condensation from occurring.
W415-1013 / A / 06.05.12
WEAR GLOVES AND SAFETY GLASSES FOR PROTECTION.
IMPEDE AIR MOVEMENT ZONES MARKED "CLEARANCE TO COMBUSTIBLES".
COMBUSTION ENgINES ARE HAzARDOUS.
CAN ALSO SET OFF SMOkE ALARMS.
STRONgLY INFLUENCE NEgATIvE pRESSURE IN THE HOUSE.
WARNING
!
SECURE.
THE CHIMNEY.
REvERSAL.
SYSTEM.