Hi-Efficiency Heating; Installation Planning - Napoleon HIGH COUNTRY NZ6000-1 Instructions D'installation Et D'opération

Masquer les pouces Voir aussi pour HIGH COUNTRY NZ6000-1:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2.5

HI-EFFICIENCY HEATING

A HOT AIR GRAVITY VENT SYSTEM (NZ221) may be
used to distribute heat to an adjoining room (located either
above, or beside the room containing the appliance) by way
of vents. Air fl ow through this vent must be experimented
with and the dampers of the grill adjusted manually to suit
your requirements. This may take a few attempts; thereafter
adjustments should no longer be required as is normally
experienced with your central heating system registers.
The hot air vent must be installed in an upward direction!
NEVER install in a downward direction. The hot air gravity
vent system is not to be connected to a central heating
system.
No more than two hot air gravity vents may be connected to the
appliance. Individual vent runs are not to exceed 10 feet (3m).
All hot air gravity vents must be insulated.

3.0 INSTALLATION PLANNING

CAREFULLY FOLLOW THE INSTRUCTIONS FOR ASSEMBLY OF THE PIPE AND OTHER PARTS NEEDED TO INSTALL THE
APPLIANCE. FAILURE TO DO SO MAY RESULT IN A FIRE, ESPECIALLY IF COMBUSTIBLES ARE TOO CLOSE TO THE
APPLIANCE OR CHIMNEY AND AIR SPACES ARE BLOCKED, PREVENTING THE FREE MOVEMENT OF COOLING AIR.
DO NOT DRAW OUTSIDE AIR FROM GARAGE SPACES. EXHAUST PRODUCTS OF GASOLINE ENGINES ARE HAZARDOUS.
DO NOT INSTALL OUTSIDE AIR DUCTS SUCH THAT THE AIR MAY BE DRAWN FROM ATTIC SPACES, BASEMENTS OR
ABOVE THE ROOFING WHERE OTHER HEATING APPLIANCES OR FANS AND CHIMNEYS EXHAUST OR UTILIZE AIR.
THESE PRECAUTIONS WILL REDUCE THE POSSIBILITY OF APPLIANCE SMOKING OR AIR FLOW REVERSAL. THE
OUTSIDE AIR INLET MUST REMAIN CLEAR OF LEAVES, DEBRIS ICE AND/OR SNOW. IT MUST BE UNRESTRICTED WHILE
APPLIANCE IS IN USE TO PREVENT ROOM AIR STARVATION WHICH CAN CAUSE SMOKE SPILLAGE AND AN INABILITY
NEGATIVE PRESSURE WITHIN YOUR HOME MAY INADVERTENTLY AFFECT YOUR APPLIANCE.
TO PREVENT CONTACT WITH SAGGING OR LOOSE INSULATION, THE APPLIANCE MUST NOT BE INSTALLED
AGAINST VAPOUR BARRIERS OR EXPOSED INSULATION. LOCALIZED OVERHEATING COULD OCCUR AND A FIRE
DO NOT USE MAKESHIFT COMPROMISES DURING INSTALLATION. DO NOT BLOCK OR RESTRICT AIR, GRILLE OR
KEEP HAND TOOLS IN GOOD CONDITION, SHARPEN CUTTING EDGES AND MAKE SURE TOOL HANDLES ARE
ALWAYS MAINTAIN THE MINIMUM AIR SPACE REQUIRED TO THE ENCLOSURE TO PREVENT FIRES.
WEAR GLOVES AND SAFETY GLASSES FOR PROTECTION.
TO MAINTAIN A FIRE. SMOKE SPILLAGE CAN ALSO SET OFF SMOKE ALARMS.
LOUVRE OPENINGS. DO NOT ADD A HOOD.
VENTING KIT
GRAVITY VENT OPTION
- 2 DUCTS
WARNING
!
COULD RESULT.
SECURE.
INSTALLATION
GRAVITY VENT OPTION
- 1 DUCT
:
NI
NG
LY
W AR
ER
ON
OW
T:
BL
TI ON
EN
EC
EM
LA
NN
TI SS
DE
CO
IO
N
IE
:
AV
ER
EX
ER
T
NG
AI
R
NN
UF
FL
EN
NI
N
CO
SO
EM
W AR
IO
UL
ST
LY
SE
M BU
ON
T:
CO
EN
EM
NT
TI SS
RA
T
ER
M BU
EN
AV
CO
EM
AI
R
UL
SE
NO DUCTING
68.3A
W415-1501 / 05.15.15
9
EN

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Nz6000-1

Table des Matières