Table des Matières
Publicité
9. MONTAGE DE LA COIFFE
9.1. Properly insert the comfort padding
into the helmet.
9.2. Slip the left front flap of the liner into
its seat by slightly deforming the upper
shell sealing edge (Fig. 13). Repeat the
same steps for the central front and right
front flaps.
Fig. 13
9.3. Correctly turn up the shell sealing
edge and press downwards in line with
the three front flaps (left, central and
right) until they are fully fastened to the
support. Make sure that the front helmet
area is as shown in Fig. 14.
Fig. 14
9.4. Fasten the two side buttons on the
back of the rear part of the comfort
padding to the corresponding seats on the
rear support fixed to the polystyrene inner
shell (Fig. 11).
9.5. Spread out the inner comfort padding
and make it stick to the inner shell by
applying pressure first in the upper zone,
so that the hook and loop fastener strap on
the top of the inside of the shell grips, and
then along the circumference.
10. ASSEMBLY OF THE CHIN
STRAP COVERING
The right and left chin strap covering are
different from each other (Fig. 10B).
10.1. After identifying the left covering
strap, insert the release mechanism of the
chin strap inside of it in line with the free
end of the "hook and loop fastener" until it
comes completely out from the central slot.
Press the free end of the strap over the chin
strap band in line with the "hook and loop
fastener" and pull the strap to stretch it out
completely (Fig. 10A).
10.2. Repeat these steps with the right
covering strap.
10.3. Make sure the straps are secured by
gently pulling them towards the inside of
the helmet.
10.4. If the release mechanism is the D-Ring
type, check that the anti-fluttering snap
button on the left strap only is correctly
placed past the two D-rings (Fig. 10B).
9
Publicité
Table des Matières
