Table des Matières
Publicité
Fig. 2 A
0
1. PEAK ADJUSTMENT
1.1. Loosen the tightness of the upper central
threaded cover plate "A" by rotating it counter-
clockwise (Fig. 3).
1.2. Rotate the peak on the side cover plates
"B" to adjust it to the desired posi- tion, which
is the highest one when riding on the road (see
position "0" in Fig. 1).
1.3. Lock the peak in the desired position by
tightening the upper central threaded cover
plate "A"; check that the side cover plates "B"
are not loose (Fig. 3).
Fig. 3
2. PEAK EXTENSION
ADJUSTMENT
2.1. Completely unscrew the internal screws
located at both ends of the peak extension
(Fig. 2B).
2.2. Remove the extension from the peak;
then put it back in one of the three possible
positions, which when riding on the road is
the one farthest back (see position "0" in Fig.
2A), by inserting its side pins in the specific
holes at the two ends of the peak.
2.3. Tighten the internal screws while
checking that the peak extension is posi-
tioned symmetrically on the peak.
3. PEAK DISASSEMBLY
3.1. Completely unscrew the threaded side
Fig. 2 B
cover plates "B" by rotating them counter-
clockwise so that the side ends of the peak
detach from the helmet shell (Fig. 3). Pay
attention not to lose the two air intakes
placed between the peak and the shell
(Fig. 2B).
3.2. Completely unscrew the upper central
threaded cover plate "A" by rotating it
counter-clockwise (Fig. 3). Remove the peak
from the helmet, paying particular attention
not to lose the trim of the upper central
threaded cover plate "A" placed between
the peak and the shell (Fig. 2B).
4. PEAK ASSEMBLY
Check that the air intakes are properly
hooked to the peak as they were originally
(Fig. 2B).
4.1. Place the trim of the upper central
cover plate "A" in line with the threaded hole
and place the peak on the shell. Insert the
upper central threaded cover plate "A" into
the hole and fasten by rotating it clockwise
without tightening it completely (Fig. 3).
4.2. Insert the left side cover plate "B" into
the relevant seat on the shell and tighten
it completely (Fig. 3). Repeat the same
operation on the other side of the helmet.
4.3. Complete the adjustment of the
position of the peak and its extension as
pre- viously described (see steps 1.2., 1.3.
and 2.).
WARNING: Check that the cover
plates, internal trim and air intakes, which
are interposed between the peak and the
helmet shell, keep the peak steady in the
desired position.
- Do not use the helmet if the peak and
peak extension have not been assem- bled
and adjusted properly.
- Do not install the peak without the
internal trim of the cover plates and air
intakes.
- In case of malfunctioning or damages,
please contact an authorized SHARK
dealer.
5
Publicité
Table des Matières
