shark VARIAL RS Sécurité Et Instructions D'utilisation page 14

15. HYDRATION SYSTEM HOSE
ASSEMBLY
To fasten the hydration system hose,
slightly buckle the free part of side hose
clip "A" and put the hose inside it. Then
buckle seat "B" of the inner chin guard and
insert the initial part of the hose with the
suction valve inside it. Adjust the length
of the hose by sliding it into housings "A"
and "B" and continue to assemble the
hydration system following the relevant
instructions
provided by its manufacturer.
16. HYDRATION SYSTEM HOSE
DISASSEMBLY
To disassemble the hydration system hose,
slip off its initial part by buckling seat "B"
of the inner chin guard. Then remove the
hose from side hose clip "A" while buckling
it slightly.
17. HOSE CLIP DISASSEMBLY
To remove fastening side hose clip "A"
from the "READY FOR CAMEL BAG" strap,
buckle its side parts and remove them
from the strap (Fig. 23).
14
Fig. 23
and recommendations
18. HOSE CLIP ASSEMBLY
To assemble side hose clip "A" on the
"READY FOR CAMEL BAG" strap, insert
first one and then the other deformable
side part of the clip under the "READY
FOR CAMEL BAG" strap until they are
completely fastened while taking care to
position the free and deformable fastening
part of the hose facing upward (Fig. 20).
WARNING: Do not use for any reason
the "READY FOR CAMEL BAG" straps
and/or the hose clip for any purpose other
than those described above.
- Always check that the side hose clip
does not become entangled with clothing
or obstructs movement of the head
and helmet, which must always be free.
Verify this by wearing all your clothing,
including any neck and/or body braces
and protectors normally used in off-road
sports. If necessary, remove the side hose
clip from the helmet.
- Remove the side hose clip and fold back
the "READY FOR CAMEL BAG" strap if a
hydration system is not used.
- Fasten the side hose clip only to the
"READY FOR CAMEL BAG" strap.
- Do not fasten the side hose clip to the
cheek pads and/or removable padding.
- Do not modify or tamper with the helmet
components to install the hydration
system. Check that the hydration system
hose is compatible with the hose clip and
deformable seat of the chin guard.
- In case of doubt, malfunctioning or
damage, please contact an SHARK
authorized dealer.