shark VARIAL RS Sécurité Et Instructions D'utilisation page 13

"CAMEL BAG" ARRANGEMENT
FOR THE HYDRATION SYSTEM
The helmet is designed to facilitate
installation of a hydration system (not
supplied) and fastening its hose. It includes
(Fig. 20):
B
Fig. 20
- a side hose clip "A", on the "READY FOR
CAMEL BAG" strap, useful for fastening
the hydration system hose;
- a deformable seat "B" on the lower edge
of the inner chin guard for positioning the
end of the hose with the suction valve near
the mouth.
The "READY FOR CAMEL BAG" strap and
the deformable seat "B" are on both sides
of the helmet.
If you do not use a hydration system,
we recommend removing hose clip "A"
(see instructions below) and positioning
the "READY FOR CAMEL BAG" straps
behind the pads of the removable cheek
pads. To do so, pull the bottom part of
the pad of the left cheek pad upwards
to release brackets "C" and "D" from the
corresponding plates between the outer
shell and the polystyrene cheek pad (Fig.
21).
Fig. 21
A
Then place the "CAMEL BAG" strap against
the polystyrene cheek pad (Fig. 22).
Fig. 22
B
Afterwards insert brackets "C" and "D"
in the corresponding plates between the
outer shell and the polystyrene cheek
pad, then press until they are fastened
(Fig. 21).
Repeat these steps with the right cheek
pad.
C
D
13