Table des Matières
Publicité
11.ASSEMBLY OF THE INNER
EXPANDING FOAM PADDING
OF THE CHEEK PADS
11.1. Gently put the inner expanding foam
padding inside the fabric lining of the left
cheek pad (Fig. 9). Carefully spread out
the padding while checking that there are
no wrinkles in the cheek pad fabric lining.
11.2. Insert the upper "B" and lower "C"
flaps of the frame in their loops on the
back of the frame (Fig. 8).
11.3. Hook the three eyelets of the rear
frame of the left cheek pad near the two
"A" hooks (top and front) and snap button
"D" (rear) on the back (Fig. 8).
11.4. Repeat these steps with the right
cheek pad.
WARNING: the rear eyelet with its snap
button "D" has a shape different from
that of the front and top eyelets and of
the corresponding hooks "A".
12. CHEEK PAD ASSEMBLY
12.1. Take the pad of the left cheek pad
and check that the safety lever on the
back is in the opening position (Fig. 15).
12.2. Put the left cheek pad inside the
helmet and insert the rear bracket "B"
in the corresponding plate between the
outer shell and polystyrene cheek pad by
pressing until it is fastened (Fig. 7).
10
Fig. 15
12.3. Insert the chin strap in the
passageway of the cheek pad padding and
press near the rear snap fastener placed on
the back to fasten it to the relevant seat on
the polystyrene cheek pad (Fig. 6).
12.4. Press the pad of the left cheek pad
against the polystyrene cheek pad and at
the same time turn it inwards to fasten the
front and top hooks on its back. (Fig. 5).
12.5. Press the safety lever upwards in line
with the fastening area of the red strap to
turn it towards the cheek pad padding until
it reaches its closing position. (Fig. 4).
12.6. Check that the fastener and hooks
are firmly fastened by slightly pulling the
pad of the cheek pad towards the inside
of the helmet, then check that it re- mains
adherent to the polystyrene cheek pad.
12.7. Insert front bracket "A" in the
corresponding plate between the outer
shell and polystyrene cheek pad, then
press it until it becomes fastened (Fig. 7).
Place the front red strap against the inner
surface of the chin guard.
12.8. Repeat these steps with the right
cheek pad.
WARNING: the buttons are not hooked
until a click is heard. Check that the strap
comes out properly from the cheek pad
padding.
WARNING:
If
equipped with the double D-Ring
retention system, pull it down as indicated
in the attached double D-Ring label.
- Remove the inner comfort padding only
when cleaning or washing is required.
- Never use the helmet if all parts of
the inner comfort padding have not been
correctly and completely reassembled.
- Delicately hand-wash in lukewarm water
(max. 30° C) and neutral soap.
- Rinse with cold water and allow drying
at room temperature, away from direct
sunlight.
your
helmet
is
Publicité
Table des Matières
