shark VARIAL RS Sécurité Et Instructions D'utilisation page 11

- Never machine-wash the inner comfort
padding.
- The inner polystyrene is an easily
deformable material. It is apt to change
or get partially destroyed to help absorb
shocks.
- Do not modify or alter the helmet's
internal polystyrene components in any
way.
- Clean the inner polystyrene components
with a damp cloth only and allow it to dry
at room temperature away from direct
sunlight.
- Never use tools or equipment of any sort
to carry out the steps described above.
13. CREATING SPACE
FOR GLASSES
13.1. Remove the left cheek pad from the
helmet (see instructions above).
13.2. Unhook the rear frame eyelet of the
cheek pad in line with the top hook "A"
shown on its back (Fig. 16).
13.3. Take the top flap "B" of the frame
out of the loop on the back of the frame
(Fig. 16).
B
Fig. 16
13.4. Gently remove the inner expanding
foam padding from the fabric lining of the
cheek pad (Fig. 17).
13.5. Remove the upper part of the inner
pre-punched padding (Fig. 17), then
correctly put back the remaining padding
part in the cheek pad.
NOTE: it is recommended to keep the
removed padding for any subsequent
reuse.
13.6. Put the top flap "B" of the frame
back in the loop on the back of the cheek
pad and refasten the eyelet in line with
the top hook "A" on the back (Fig. 16).
13.7. Refit the complete cheek pad on
the helmet (see instructions above).
13.8. Repeat these steps with the right
cheek pad.
14. REMOVING SPACE
FOR GLASSES
14.1. Remove the left cheek pad from the
helmet (see instructions above).
14.2. Unhook the rear frame eyelet of the
cheek pad in line with the top hook "A"
A
shown on its back (Fig. 16).
14.3. Take the top flap "B" of the frame
out of the loop on the back of the frame
(Fig. 16).
14.4. Properly insert part of the
previously removed padding in the fabric
lining of the cheek pad (Fig. 17).
14.5. Put the top flap "B" of the frame
back in the loop on the back of the cheek
pad and refasten the eyelet in line with
the top hook "A" on the back (Fig. 16).
14.6. Refit the complete cheek pad on
the helmet (see instructions above).
14.7. Repeat these steps with the right
cheek pad.
Fig. 17
11