Table des Matières
Publicité
CHIN GUARD AIR INTAKE
FILTERS
The chin guard air intake is fitted with a fixed
external filter in metal mesh that allows easy
air intake while limiting the entry of insects or
small stones, and a second removable internal
filter assembled in the inner chin guard that
can be removed from its housing to increase
the flow rate of the air intake and/or to be
washed.
19. DISASSEMBLY OF
THE REMOVABLE INTERNAL
FILTER
To remove the removable internal filter, pry
its holding frame towards the inside of the
helmet near the upper right corner of the
frame. Unfasten the holding frame from the
deformable internal chin guard by slipping the
fastening flaps out of the slots on the internal
chin guard.
Fig. 25
Completely remove the holding frame from
the chin guard and pull the filter out from its
housing in the internal chin guard.
Then reassemble the filter holding frame on
the internal chin guard by inserting, one by
one, the side and then upper fastening flaps
of the frame in the corresponding slots on
the internal chin guard applying light pressure
above (Fig. 25).
20. ASSEMBLY OF THE
REMOVABLE INTERNAL FILTER
To replace the removable internal filter,
remove its holding frame as explained above,
insert it and place it properly in its housing in
the chin guard. Then reassemble the holding
frame as explained above (Fig. 25).
WARNING: If you wish to use the
helmet without the removable internal
filter, it is recom- mended to always install
the filter holding frame.
Publicité
Table des Matières
