shark VARIAL RS Sécurité Et Instructions D'utilisation page 8

7.DISASSEMBLY OF THE CHIN
STRAP COVERING
To remove the chin strap covering from
the strap, proceed as follows after
removing the cheek pads from the helmet
(see instructions above).
7.1. Pull the left covering strap in line with
the "hook and loop fastener" to separate
it from the chin strap band and then take
it off (Fig. 10A).
7.2. Repeat these steps with the right
covering strap.
Fig. 10 A
R=Right
Fig. 10 B
8
L=Left
8. LINER DISASSEMBLY
8.1. Pull the back of the comfort padding
towards the inside of the helmet to
unhook the two side buttons on its back
from their seats on the rear support fixed
to the polystyrene inner shell (Fig. 11).
Fig. 11
8.2. Unhook the left front flap from the
support fixed to the inner shell below
the trim of the upper edge of the shell
by slightly pulling the comfort padding
towards the inside of the helmet (Fig.
12). Repeat the same steps for the central
front and right front flaps.
Fig. 12
8.3. Completely remove the comfort
padding from the helmet.