Connecting The Power Supply; Insert Batteries; Connect The Power Supply Unit - Seca 285 Mode D'emploi Et Garantie

5.5 Connecting the power supply

Insert batteries

Connect the power
supply unit
84 •
The head slide is supplied with power from batteries.
The scales and the multifunctional display are run with
a power supply unit.
The batter holder supplied already contains 4 Mignon
batteries, type AA, 1.5 volt. To connect the power
supply for the head slide, proceed as follows:
1. Remove the cover of the battery compartment.
2. Remove the connection cable from the battery
compartment.
3. Connect the battery holder to the connection cable.
4. Insert the battery holder into the battery
compartment.
ATTENTION!
Damage to device and malfunction due to
clamped or pinched cable
− Lay the battery cable before closing the
battery compartment so that it cannot get
clamped between the cover and the battery
compartment.
5. Slide the cover onto the battery compartment until
it audibly latches into position.
The connection for the power supply unit is located on
the underside of the base of the device. To connect the
power supply for the scales and multifunctional display,
proceed as follows: