Displayed Messages - Franke FMY 45 CM XS Manuel D'installation Et D'utilisation

DISPLAYED MESSAGES

MESSAGE
FILL TANK
GROUND TOO FINE
ADJUST MILL AND
(alternating with) PRESS OK
GROUND TOO FINE
ADJUST MILL AND
(alternating with) PRESS OK
(then) FILL TANK!
EMPTY WASTE COFFEE
CONTAINER
INSERT WASTE COFFEE
CONTAINER
ADD PRE-GROUND
COFFEE
PLEASE DESCALE!
(alternating with) MEDIUM
CUP NORMAL TASTE
LESS COFFEE
FILL BEAN CONTAINER
INSERT BREWING UNIT
CLOSE DOOR
FMY 45 CM XS
MEANING
The water tank is empty or not
properly in place.
The grinding is too fine and the
coffee is delivered too slowly.
The machine cannot make coffee
as there is air in the hydraulic
circuit. Possible cause: the filter
has not been installed correctly.
The tank has been removed
during delivery.
There is air in the hydraulic
circuit.
The waste coffee container (A4)
is too full or more than 3 days
have passed since you last made
coffee (this guarantees correct
hygiene of the machine).
After cleaning, the waste coffee
container has not been replaced.
The "pre-ground coffee" function
has been selected without
placing any pre-ground coffee in
the funnel.
The funnel (A21) is blocked.
The machine must be descaled.
Too much coffee has been used. Select a milder taste or reduce the
The coffee beans have run out.
The brewing unit has not been
replaced after cleaning.
The service door is open.
– 25 –
WHAT TO DO
Fill the tank with water and/or insert it
correctly, pushing it as far as it will go.
Turn the grinding adjustment knob one
click clockwise towards "7".
Make sure the filter (A9) is propertly
installed and that the installation has been
carried out correctly.
Insert the tank and press the OK icon (B9).
"HOT WATER PRESS OK" is displayed. Press
the OK icon (B9) again. The appliance is
once again ready for use.
Empty the waste coffee container and clean,
then replace. Important: when removing the
drip tray, the waste coffee container MUST
be emptied, even if it is not completely full.
If this is not done, when you make the next
coffees, the waste coffee container may
fill up more than expected and clog the
machine.
Open the service door and insert the
waste coffee container.
Extract the appliance and place
pre-ground coffee in the funnel.
Empty the funnel with the help of a knife
as described in the section "Cleaning the
pre-ground coffee funnel".
The descaling procedure described in
the "Descaling" section needs to be
performed as soon as possible.
quantity of preground coffee, then make
the coffee again.
Fill bean container.
Insert the brewing unit as described in the
section "Cleaning the brewing unit".
Close the service door.
EN