Franke FMY 45 CM XS Manuel D'installation Et D'utilisation page 24

EN
Press the two red release buttons inwards and at
X
the same time pull the brewing unit outwards
Fig. 34
(Fig. 39).
Fig. 38
IMPORTANT: Do not use washing up liquid
to clean the brewing unit. It would remove the
lubricant applied to the inside of the piston.
Soak the brewing unit in water for about
X
5 minutes, then rinse.
After cleaning, replace the brewing unit (A5) by
X
sliding it onto the internal support and pin at the
bottom, then push the PUSH symbol fully in until
it clicks into place (Fig. 42).
Note: If the brewing unit is difficult to insert,
you must first adapt it to the right dimensions by
pressing it forcefully from the bottom and top
(Fig. 43).
Once inserted, make sure the two red buttons
X
have snapped out (Fig. 44)
Fig. 43
Replace the drip tray and waste coffee container.
X
Close the service door.
X
Fig. 35
Fig. 39
Fig. 42
Fig. 44
FMY 45 CM XS
Cleaning the milk container
Always clean the tubes inside the milk container
when you prepare milk. If there is still milk in the
container, do not leave it out of the refrigerator for
longer than strictly necessary. Clean the container
each time you prepare milk as described in the
section "Making cappuccino".
Note: All components can be washed in a
dishwasher, placing them in the top basket of the
dishwasher.
Turn the milk container lid clockwise then remove it.
X
Remove the milk spout and intake tube (Fig. 45).
X
Remove the frothed milk regulator (F) by pulling it
X
outwards.
Wash all the components thoroughly with hot water
X
and mild washing-up liquid. Make sure there are no
milk residues left inside the holes (Fig. 46) and the
groove on the fine end of the frothed milk regulator
(Fig. 47).
H
Fig. 45
Check that the intake tube and spout are not
X
clogged with milk residues.
Replace the frothed milk regulator, milk spout and
X
intake tube.
Replace the milk container lid.
X
– 24 –
S
M
Fig. 45
G
H
Fig. 47
F