FLUX VISCOFLUX mobile S Notice D'instructions Originale page 49

Remove the cover upwards.
>
Remove the two screws (3) of the
>
final position switch with a clamping
screw driver. Move the final position
switch to the desired position (the
final position switch can be adjusted
7 times by 50 mm). Screw in the two
screws and tighten them.
Open the cable conduit (4). Open the
>
cable gland (5).
Push the cable through the cable
>
gland until the cable has no more
reserve. Re-tighten the cable gland
and close the cable conduit.
When laying the cable pay attention
that damage by the toothed belt or the
rolls of the lifting sledge is avoided.
The rolls must not be blocked by the
cable.
Mount cover and cable conduit in reverse order.
Operating instructions VISCOFLUX mobile S
3
4
5
49 / 96