FLUX VISCOFLUX mobile S Notice D'instructions Originale page 58

If the pumped material is water-soluble or can be cleaned with an agent which is not
flammable, the pump with the follower plate and connected hose may be pre-cleaned
by means of cleaning agent circulation. In order to do so, place the pump with follower plate
over an sufficiently large container with cleaning agent. When the motor is switched on, the
pump with follower plate lowers automatically. In order to avoid that the follower plate lowers
on the bottom of the container and the cleaning agent circulation is interrupted, place an
appropriate stop below the follower plate or adjust the stop (1).
For variants with control unit and end position stop the illuminated push-button "end position"
(see page 45) might have to be actuated that the pump motor runs.
Attention – bring the stop in its previous position after cleaning.
For a thorough cleaning of all components the pump has to be disassembled (see operating
instructions of pump).
Attention – pump with follower plate will lower automatically when the motor is switched on.
> Prior to dismantling the drum emptying system, disconnect the power supply and the
compressed-air supply.
> Dismount the material hose.
Caution - pumped material may exit.
> Separate the pump from the follower plate by means of the clamp connection.
Caution - pumped material may exit.
> Disassemble the follower plate.
> Separate the pump from the process device.
> Protect the motor and the control unit against the cleaning agent.
Clean the process device
> Remove coarse dirt with a damp sponge or cloth.
> Spray the process device with an appropriate cleaning agent or disinfectant and then
rinse with water.
> The stainless steel front and back covers can be removed for cleaning, if necessary.
The removal of the covers is described on pages 49, 50 and 60.
>
58 / 96
1
Clean plastic parts or the supply cable only with an appropriate cleaning
agent.
Operating instructions VISCOFLUX mobile S