LEM MachineTest 204 Manuel D'utilisation page 6

SAFETY REGULATIONS
This symbol means: Please read the operating instructions with particular
care!
Meaning of the
Intermittent use! An acoustic signal (beep) will
-
indicate a measuring time of 10s. To avoid
unintended overheating don't measure continuously
with 10A. If the instrument is overheated the "HOT"
control LED at the display will indicate this and stop
the measurement.
- Use only standard or optional test leads supplied by your
dealer, otherwise the tests may be highly dangerous!
- Avoid direct contact with test tips, hazardous voltage
may be applied!
- Do not connect external voltage to test terminals
_
∼
otherwise the instrument may be damaged or internal
fuse may blow!
+ ∼
- If the START/STOP control lamp can not be switched off
pressing the START/STOP key, then stop the
measurements immediately, unplug the mains cord and
let the instrument to be serviced!
symbol: Hazardous voltage generated by the
instrument may be applied to the test terminals!
5