Scope Of Application; Turn Off; Lance And Pistol; Machine - Dibo JMB-C+ WWC Mode D'emploi

E N
T U R N O F F

SCOPE OF APPLICATION

Efficient high pressure cleaning is achieved by following a few guidelines
combined with your own experiences. Each cleaning job is different and
specific, therefore contact DiBO for the best solution in your application sector.
• Using cleaning products (if applicable): the surface to clean should be sprayed
so the product can act during some time (do not let it dry!) before cleaning
with high pressure jet. Cleaning agents can increase the cleaning effect if they
are used correctly! Always follow/consider the safety instructions of the used
product!
• Cold water (high pressure) cleaning: removal of (mild) impurities/pollution and
rinsing.
• Hot water (high pressure) cleaning (if applicable): the cleaning effect will be
such improved through increasing the temperature (set the temperature
experimentally according to the application).
• Cleaning via lance with rotating head (if applicable): cleaning method to
remove tough layers of dirt.
• Cleaning using a steam lance (if applicable): this steam function (by
overheating water) is used in 'sensitive' cleaning applications (eg: damage
sensitive surfaces) where there is stubborn dirt (eg: degreaser) is removed by
using steam.
Please note: this application has high cleaning
temperatures and requires various safety measures!
Intended Use: this pressure washer has been developed for use in various
professional applications (eg: building technology, cleaning technology,
industrial, transport sector, ...).

Turn off

When you interrupt or stop the cleaning activities, be sure to bear in mind the
following instructions in order to be able to switch off the JMB-H in the right way.

LANCE AND PISTOL

Uncouple the lance and put it away. Put the operating switch on OFF. Take
the plug out of the socket. Close the water supply. Roll up the high and low
pressure hoses.

MACHINE

Drain off the water from the supply tank (drain off tap is situated under the
trailer). If necessary, clean the water filter. Slightly clean the machine with a
tissue. Close the protection cover and bolt the locks. Hold the manual and the
ignition keys within arm's reach.

WATER OUTLET

Clean to own need the water supply.

PUT AWAY MACHINE

Store the machine in a dry and frost-free place at a horizontal and stable subsoil.
Pull the trailer brake. Turn the nose wheel downwards and bolt it. Untie the
safety cable as well as the electricity wire from the trailer. Uncouple the JMB
from the pole.
DiBO 26