Before Commisioning; Accomplish Water Supply And Water Discharge; Accomplisch Water Supply; Discharging Water - Dibo JMB-C+ WWC Mode D'emploi

E N
B E F O R E C O M M I S I O N I N G

Before commisioning

Before every start up, all essential parts of the high-pressure cleaner must be
checked, by taking them in consideration like for example: is the lance coupling
tight, check the high pressure hoses and the electrical wiring on damages.
Check, before plug in the plug in the socket or the electric indications on the
name plate are suitable with the values of the main power supply (for example:
elektric tension,...) (if applicable). Operate the machine. Rinse the hoses,
spray gun and lance minimum 1 minute with clean water (aim the spray gun in
free space). Check whether hazardous substances such as asbestos and oil
can come loose from the object to be cleaned and pollute the environment.
Persuade yourself of the safety requirements mentionned in previous chapter.
Leave the main switch / key switch on position 0- OFF. Before putting into
use: close the protective cap (if applicable) & at option tarpaulin (if applicable):
dismount the tarpaulin.

ACCOMPLISH WATER SUPPLY AND WATER DISCHARGE

1

Accomplisch water supply

The water supply line can be connected (according circumstances) on their
own water supplies (under pressure, ...) or on a drinking water supply with a
water barge. When the machine is connected to the drinking water supply, the
existing regulations about that must be observed (EN 1717). If necessary place a
filter in the water supply line.
• Water supply under pressure:
Maximum hose length 50 m (160 ft), minimum hose diameter (internal) 12.7
mm (1/2").
Check the water pressure by means of a watermeter.
• Water supply at units with HT- pumps:
When the unit has a HT- pump a pre-pressure pump must be installed.
2

Discharging water

Verify whether all water drains are correctly connected to the sewer system.
Take the necessary measures to ensure that the waste water is pure enough to
discharge/drain.
3

Anti- legionella bacterium measure

If the machine has estood still some time, the water in the machine must be
discharged above a drain.
Stagnant water that is warm between 20-55 ° C can cause the legionella
bacterium.
• Clean therefore the pipes and vessels annually.
• Rinse periodically.
• Remove possible sediment.
4

Filling the fuel tank

Avoid mess of fuel, certainly on warm machine parts. The fuel should also
be filtered to prevent dust or dirt from entering the tank. Use the same type
of diesel fuel as used in cars. Use of other types of fuel could damage the
motor. Fuel is not a fleeting toxic substance, do not inhale fumes unnecessary.
See "Technical data" on page 35 for tank reserve and fuel type.
Pay attention to for static electricity. Switch off your mobile
phone and touch a metal object, the machine frame.
At temperatures under 8°C the fuel starts coagulate (paraffin
dissidence). As a result, difficulties can arise at starting the diesel
motor and/or burner. DiBO advise to add an coagulation point - or
flow improvement during the cold period (winter months) to the fuel.
As an alternative "winter diesel" can be refuelled in a filling station.
DiBO 14