Transport; General; Storage At Freezing Temperatures - Dibo JMB-C+ WWC Mode D'emploi

1 low pressure coupling
2 safety valve
3 high pressure coupling

TRANSPORT

1

General

• Close the protection covers
• Check the tension of the tires (ca 3 bar) and profile depth (min. 2 mm).
• Couple the JMB on and make sure that the shaft is connected firmly.
• By pulling the shaft powerful up u can check if the coupling is put on firmly.
• Attach the nose wheel carefully on the towing hook eye it is meant for it.
This cable is a safety precaution and is used as an emergency break, when
suddenly the coupling gets loose during the drive.
• Attach the electrical cable for the lighting, and check it.
• Unbolt the overrun brake (if present).
• The JMB-H must always be provided with a good readable, official registration
plate, according to the regulations apply to your country. ,The plate must
be attached properly on the rear and in this way that the lighting lights the
complete plate.
2

Storage at freezing temperatures

Add antifreeze to the water in the water supply tank, in order that the machine
can suck this liquid. Get the hose from the spray gun and turn on the machine.
Spray until the antifreeze water comes out of the gun. This indicates that the
whole system is now filled with antifreeze. By spraying the water again into
the tank, you get a closed circuit and no antifreeze liquid gets lost. Turn off the
machine as described.
- - - - - - - - - - - - - - - - - - -
Antifreeze is an additive which may absolutely not been drain/
discharged without permission. You have to collect the outlet
antifreeze water in a reservoir. This is also the case when you
use the machine once more, the antifreeze water which has
been left in the machine will then flow through. Please do
always take into account the matching security measures.
TIP: You can use the collected water with antifreeze several times !
Remark:
pay attention to the water supply hose & supply water
filter, these are not filled with antifreeze agent! You can uncouple the
supply hose/water filter and put away the hose/filter frost free.
You also can drain the water from the hose (eg. : by blowing with compressed
air) or through the water filter (by loosening the basket and draining the water
from the hose).
Option: filling set antifreeze (see photo below - 1.230.100/101/102).
First loosen the basket from the water filter. Connect the filling set antifreeze to
the low pressure hose and to the high pressure hose (closed circuit).
Put the cleaner on idle speed and operate the spray gun. Keep the spray gun
pressed till the water flows out of the low pressure hose and there is filled with
antifreeze till the water filter. Turn the basket back on the filter and then push
again on the spray gun. Hold the spray gun until also the water filter (note the
color of antifreeze in the water filter) is filled with antifreeze (+- 20 litres).
Turn off the cleaner and disconnect the antifreeze filling set of the hoses.
The low pressure side is now also filled with antifreeze.
1
DiBO 27
2
3
E N
T U R N O F F