Before Bring In Use; Accomplish Water Supply And Water Outlet; Accomplish Water Supply; Carry Away Water - Dibo ECN Mode D'emploi

2. Before bring in use

For each start up all substantial parts of the high pressure cleaner must be checked by taking them in consideration
like for example: is the lance joint still stuck firmly, check high pressure hoses and electric wiring on damages. Check,
before plugging the plug in the socket, if the electric indications on the name blade are suitable with the values of the
main supply (for example: electric tension,...).
Operating the machine. Rinse the hoses, gun and lance minimum 1 minute with clean water.
(Aim the gun in the free space). Check if of the object to clean can come dangerous goods like e.g. asbestos and oil
loose and can pollute the environment.
Persuade yourself of the safety regulations from previous chapter.
Leaves the main - and operating switch on state OFF.

2.1. Accomplish water supply and water outlet

2.1.1. Accomplish water supply

The water supply pipe can be connected (towards circumstances) on their own water supplies (under pres-
sure) or on a drinking water supply with a water barge. When the machine is connected to the drinking water
supply, the existing regulations about that must be observed ( EN 1717 ).

2.1.2. Carry away water

Check that all water outlets have been correctly connected on the sewerage.
Take the necessary measures so that the effluent is pure enough to drain.

2.1.3. Anti- legionella bacterium measure

If the machine has stood still some time, the water in the machine must be drained above an evacuation.
Stationary water that between 20-55°C warm is can cause the legionella bacterium.
ECN-M/T/L : REV 0
Water supply under pressure:
Maximum hose length 50 m (160ft), minimum hose diameter (inside) 12.7 mm (1/2").
Check the water pressure using a water meter.
- Clean therefore yearly piping and tanks.
- Remove possible sediment.
- Rinse periodically.
DiBO n.v. 47