Switching The Servo Directions Of Travel; Activating The Integrated Mixers - ModelCraft MT-600 Notice D'emploi



13. Switching the Servo Directions of Travel

If the rudder movements are not according to figure 10, you
are able to switch the running direction of every single servo
with the reverse switches (also see figure 1, item 10).
The switches are assigned as follows:
CH1 = Aileron servo
CH2 = Elevator servo
CH3 = Throttle servo/flight controller
CH4 = Rudder servo
If the switch is in the bottom position, the „regular" running
direction is set.
If the switch is pushed to the top position, „reversed" running
direction is activated.
Please observe that the centre position of the servo/rudder may have to be adjusted after switching.


14. Activating the Integrated Mixers

The remove control has a delta and a V-tail unit mixer that
can be activated with the mixer switch (also see figure 1,
item 9).
When the slider is in the bottom position, regular operation
without mixer function is active.
This setting is used for flight models that have a rudder and
elevator (see sketches in figure 10).
Figure 11
Figure 12
39