V-Tail Mixer - ModelCraft MT-600 Notice D'emploi

b) V-Tail Mixer
For a plane model with V-tail, the elevators also have to perform the rudder function. For this reason, the V-tail mixer
mixes the channels CH2 (elevator) and CH4 (rudder) so that the elevator or rudder control will always cause both
servos to run.
The servo of the right rudder flap of the V-tail has to be connected to the receiver output CH4 and the servo of the left
rudder flap of the V-tail to the receiver output CH2. The deflections of the two rudder flaps have to be according to the
figures in figure 14.
Figure 14
41