Range Test - ModelCraft MT-600 Notice D'emploi



17. Range Test

Before the first start, the range of the remote control system must be tested. It is possible to operate the transmitter at
reduced output here.
For the range test, the model should be held safety at a height of about 1 m by a helper. The model must not rest on
a metal table or metal plate for this.
Proceed as follows for the range test:
• Push the binding PDM button at the transmitter (also see figure 1, item 3) and switch on the transmitter with the
button pushed.
• Then start up the receiver.
• The green LED display for the binding function and undervoltage (also see figure 1, item 14) starts to flash in a 2
second cycle and the remote control emits a signal sound every 2 seconds.
• Move away from the model now.
• Up to a distance of 30 - 50 steps, the model has to be completely controllable.
• Continue to increase the distance until the model no longer reacts to the control signals.
• Switch the transmitter off and on again. The transmitter now works at full transmission output.
• At full signal strengths, the model has to react reliably to the remote control signals again.
After about 60 seconds, the remote control transmitter will automatically switch from reduced to full
transmission output.
Attention!
Never start your model while the transmitter output is still decreased!
44