Installing The Receiver - ModelCraft MT-600 Notice D'emploi

b) Installing the Receiver
Installation of the receiver depends on the model. For this reason, you should always follow the recommendations of
the model manufacturer regarding the installation. Regardless of the model, you should always try to install the receiver
so that it is protected from dust, dirt, moisture and vibration in the best possible way.
Keep enough distance from motors and electronic flight or speed controllers. Metal or carbon parts have a shielding
effect and thus may considerably impair reception. In this case, it is sensible to relocate the aerial outwards through a
bore in the fuselage.
Two-sided adhesive foam (servo tape) or rubber rings that hold the foam-wrapped receiver securely in place are
suitable for fastening the receiver.
Attention!
The aerial wire (1) length is determined precisely.
For this reason, you must not roll up the wire,
place it in a loop or cut it off. This would decrease
the range significantly and thus pose a
considerable safety risk.
Pull the aerial wire out of the model through an
opening in the body directly behind the receiver.
Figure 7
35