Turn Off; Lance And Pistol; Cleaner; Water Outlet - Dibo JMB-M Mode D'emploi

Masquer les pouces Voir aussi pour JMB-M:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5. Turn off

When you interrupt or stop the cleaning activities, be sure to bear in mind the following instructions in order to be able
to switch off the cleaner in the right way.

5.1. Lance and pistol

Uncouple the lance and put it away. Put the operating switch on OFF.
Close the water supply. Roll up the high and low pressure hoses.

5.2. Cleaner

Drain off the water from the supply tank (by means of a drain off tap beneath the trailer).
If necessary, clean the water filter(s). Slightly clean the cleaner with a tissue.
Close the protection cover and bolt the locks. Hold the manual and the ignition keys within arm's reach.

5.3. Water outlet

See chapter 1 - safety & point 2.1.2.

5.4. Put away cleaner

Store the cleaner in a dry and frost free place at a horizontal and stable subsoil.
Pull the trailer brake. Turn the jockey wheel downwards and bolt it.
Untie the safety cable as well as the electricity wire from the trailer. Uncouple the JMB-M from the pole.
5.5. Environmentally safe disposal of used fluids
No fluids (anti-scale product, oil, petrol, diesel, softener, ...) may be disposed randomly because of the environ-
ment! So make sure, if you are user, that the applicable local guidelines for environmentally friendly disposal of
these fluids (without soil pollution) are complied.

5.6. Transport

5.6.1. General

Close the protection cover. Check the pressure of the tires (ca 4 bar) and profile depth.
Couple the JMB-M on and make sure that the shaft is connected firmly.
By pulling the shaft powerful up you can check if the coupling is put on firmly.
Turn the jockey wheel and lock it.
Caution, make sure the jockey wheel is turned into the driving direction.
Please also ensure that the nose wheel will not touch the brake system / drain tap.
Set the jockey wheel like shown in picture on the left.
Attach the breakaway cable carefully on the towing hook eye it's meant for.
This cable is a safety precaution and is used as an emergency break, when suddenly the coupling gets loose
during driving. Attach the electrical cable for the lighting, and check it.
Unlock the hand brake (if present) and remove the wheel blocks. The JMB-M must always be provided with a
good readable, official registration plate, according to the applicable regulations to your country.
The plate must be attached properly on the back and the lighting lights the complete plate.

5.6.2. Storage at freezing temperatures

Frozen water in the cleaner could damage parts of the cleaner.
Remove the water from the trailer at frost temperatures, turn the jockey wheel of trailer completely down and
open the drain valve in the front of the trailer.
DiBO n.v. 82

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1.780.120

Table des Matières