Turn Off; Lance And Spray Gun; Cleaner; Water Outlet - Dibo IBH-S Mode D'emploi

5. Turn off

When you interrupt or stop the cleaning activities, be sure to bear in mind the following instructions in order to be able
to switch off the cleaner in the right way.

5.1. Lance and spray gun

Put the main switch on OFF when finisch with spraying activities.
Operate the spray gun until there's no pressure anymore present in the hoses.
Uncouple the lance and put it away. Close the water supply. Roll up the high and low pressure hoses.

5.2. Cleaner

Drain off the water from the supply tank.If necessary, clean the water filter(s).
Slightly clean the cleaner with a tissue. Close the protection cover.
Hold the manual and the ignition keys within arm's reach.
Store the cleaner in a dry and frost free place at a horizontal and stable subsoil.
Press the wheel clip protections (brakes) on the swivel castors.

5.3. Water outlet

See chapter 1 - safety & point 2.1.2.
5.4. Environmentally safe disposal of used fluids
No fluids (anti-scale product, oil, petrol, diesel, softener, ...) may be disposed randomly because of the environ-
ment! So make sure, if you are user, that the applicable local guidelines for environmentally friendly disposal of
these fluids (without soil pollution) are complied.

5.5. Burner cooling

If the cleaner is used with hot water, it is essential to turn off the boiler and circulate cold water until the water
output has reached an ambient room temperature, to prevent or minimize limescale deposits in the circuit.

5.6. Transport

5.6.1. General

Pay attention at transport to the following:
Keep the machine as much as possible horizontally during transport, one prevents that there leaks oil from
the pump. Load the machine using a lift truck, hydraulic loading platform or a hoist.
Lash the machines (if necessary) fixed on the loading platform.

5.6.2. Storage at freezing temperatures

Frozen water in the cleaner could damage parts of the cleaner.
Therefore, drain the water from the machine at frost temperatures.
Replace the water suction hose by a short piece of hose and hang it with his end in the anti frost product
tank, so there can be anti frost aspiration. Take the lance from the spray gun and operate the machine.
Spray until there comes anti frost out of the gun. The machine is now filled with anti frost, stop the machine.
Tip: if you collect the drained anti frost water, this can be re-used afterwards.
DiBO n.v. 61 DiBO n.v. 61