Suction Danger; Danger Of Injury At The Inlet Nozzles; Faults; Preventing Material Damage - Speck pumpen BADU Jet Wave Traduction Des Instructions D'utilisation D'origine

Wg23.70.060-p
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 118
Safety
2.7.5

Suction danger

The following dangers can lead to drowing:
Sucking towards, sucking in or jamming of the body or body
parts, clothing and jewellery
Knotting of the hair
Never operate the system without a suction cover, cover or a
light cover if applicable.
Do not wear loose swimwear.
Use a bathing cap if you have longer hair.
Check and clean the suction openings regularly.
2.7.6

Danger of injury at the inlet nozzles

Inlet nozzles and massage accessories operate at high pressure
and with high flow speeds. This can result in injuries to eyes or
other sensitive body parts.
Avoid direct contact of these body parts with the water jet
from the inlet nozzles or the massage accessories.
2.8

Faults

In case of a fault, immediately switch the pump off and
remove it from operation.
Have all faults repaired immediately.
Seized pump
If a pump seizes, and is switched on several times repeatedly, the
motor can be damaged. Observe the following points:
Do not switch the pump/unit on repeatedly.
Turn the motor shaft by hand. See point 6.1.1 on page 42.
Clean pump.
2.9

Preventing material damage

2.9.1

Leakage and pipe breakage

Non-observance of the curing time of the ABS bonding can result
in leaks and flooding
Observe the curing time of at least 12 hours for the ABS
bonding
Provide sufficient ground drainage
Vibrations and thermal expansion can cause pipes to break.
12 EN
01|2018

Publicité

Table des Matières
loading

Table des Matières