Assembling The Dummy Plate - Speck pumpen BADU Jet Wave Traduction Des Instructions D'utilisation D'origine

Fig. 26
6.4.2

Assembling the dummy plate

The following steps are necessary in order to assemble the
dummy plate:
1. Observe the point See point 5.6 on page 41.
2. Attach the dummy plate (30) under the support ring (28) and
fasten it to the main housing (1) using four tapping screws
(103). See "Fig. 12" and "Fig. 13" on page 27.
01|2018
Commissioning/Decommissioning
Support
WG23.70.050-2-P
EN 45