Operation; Switching The Unit On And Off; Volume Regulator; Led Colour Variations - Speck pumpen BADU Jet Wave Traduction Des Instructions D'utilisation D'origine

6.2

Operation

6.2.1

Switching the unit on and off

The unit can be switched on and off by pressing the pneumatic
button (38/1) which is built into the cover. There is no electrical
operating unit in the pool.
6.2.2

Volume regulator

The flow rate, and therefore the unit's effect, can be set
individually for the swimmer using the adjustable nozzle (54/1).
CAUTION
Injury due to massage with full nozzle stream.
 Maintain a sufficient distance in order to avoid damage to
health.
6.2.3

LED colour variations

The LED colour variations can be changed by pressing the button
38/1 repeatedly within five seconds.
Colour sequence:
• Red
• Green
• Blue
• Green – Red
• Green – Blue
• Red – Blue
• Green – Red –
Blue
The colour variation will be maintained when pressed for longer
than five sceonds.
6.2.4

Ball nozzle(s)

The direction of the ball nozzle(s) (54) can be adjusted. The
nozzles should normally be set horizontally or pointing slightly
upwards. This provides the greatest effect for swimming against
the current.
6.2.5

Air regulator

The air regulator (21/1) allows air to be added to the water jet so
that an air bubble bath effect can be attained. The amount of air
can be adjusted.
01|2018
Commissioning/Decommissioning
Change of colour:
• one second discrete
• 30 seconds slowly dimming
• flashing
• seven seconds dimming
• flickering "rolling out"
EN 43