Aligning The Support Ring; Protective Conduit And Hose For Air Regulator; Pipe Sizing - Speck pumpen BADU Jet Wave Traduction Des Instructions D'utilisation D'origine

Installation
5.2.3

Aligning the support ring

The four holes marked (1) must always be positioned at a 45°
angle to the centre axis.
Fig. 14
5.2.4

Protective conduit and hose for air regulator

Lay and fasten the protective conduit and the hose for the air
regulator above the water level.
5.2.5

Pipe sizing

Suction lines which are too long have significant disadvantages:
• Higher resistance, therefore poorer flow characteristics and a
higher risk of cavitation.
28 EN
Up
Up
(1) (1)
(1) (1)
WG23.50.054-2-P
01|2018