End Of Season Maintenance; Maintenance Summary Table - Grillo G131 Manuel D'utilisation

– Lubricate the clutch and gas wires.
– Lubricate the sliding bearing of the handle lock stud.
– Check that the clutch wire always has a little clearance.
– Remove any leaves and grass that may have deposited on the engine front grid.
– Often check oil levels and clean the air filter frequently.
– Grease the machine coupling 2 or 3 times a year, by separating the rotary tiller from the flange.
– For machines supplied with electric starter keep the charging battery clips protected with a thin
layer of Vaseline.

END OF SEASON MAINTENANCE

Wash the machine carefully; change the oil inside the engine, the gearbox and the tiller gearbox;
clean the air filter. Sharpen the tines; if they are badly worn they should be changed. Notice: when
the tines are changed it is also necessary to change the central knife.
IN CASE OF LONG IDLE PERIODS
In case the machine is not to be used for a long period, remove the battery keeping it in a dry place
and recharge it once a month at least.
PROCEDURE
Engine oil
Air filter
Cutter bar
Check that the engine intake grid is
clean
Gearbox oil
Check that blades are well-
sharpened and well-fixed
Lubricate with grease
●
recommended procedure
‫ ٭‬procedure to be carried out if necessary
Translation of the original instructions

MAINTENANCE SUMMARY TABLE

EVERY 8
check the level
change
check
replace
check blade
attachment
grease
check the level
replace
AFTER 20
HOURS HOURS
●
●
●
●
●
●
●
●
10
EVERY 50 EVERY
HOURS 100
HOURS
●
●
●
●
ONCE A
YEAR OR
EVERY 200
HOURS
‫٭‬
●